Diadia Roma
Detector for early warning of attacking FPV drones. It continuously scans video frequencies, shows the drone’s video on screen, gives a sound and light alarm and automatically switches the EW jammer on for 180 s. The sealed remote module is placed at a position or on a vehicle up to 30 m from the control unit.
Video
How it works
From scan to EW- Step 1
Scanning. The detector scans all four bands from 900 to 7500 MHz simultaneously — a full pass takes 15 s. The screen stays off to save power and the LED blinks slowly.
- Step 2
Detection. When a video signal is found, the screen and the sound and light alarm switch on. The screen shows the drone’s video, frequency, signal level and voltage. The built-in decoder switches to an inverted signal by itself.
- Step 3
Automatic EW. As soon as the drone’s video signal is located, the detector switches the EW jammer on for 180 s and then returns to scanning the air.
Specs
Tactical and technical specifications- Purpose
- Early detection of attacking FPV drones by their video signal with automatic EW activation. Stationary at positions or mobile on vehicles
- Detection bands
- 900–2200 MHz | 2800–4070 MHz | 4850–6100 MHz | 6100–7500 MHz, scanned simultaneously
- Full sweep time
- 15 s
- Automatic EW activation
- For 180 s after the drone’s video signal is located, then back to scanning
- Return to scanning
- 15 s after the video signal disappears
- Decoder
- Built-in, switches to an inverted signal by itself
- Supply voltage
- 12–28 V; full 900–2200 MHz range from 24 V, at 12 V only 900–1600 MHz
- Consumption
- 3 W search / 6 W video (1G + 7G version); 5.3 / 7 W (1.2 + 3.3 + 5.8 + 7.5 GHz version)
- Battery capacity (battery version)
- 20 000 mAh
- Distance from module to control unit
- Up to 30 m (tested cable length)
- Alerts
- Screen, sound and LEDs; audible low-battery warning
- Module connection
- Antenna cable with GX12 (5-pin) or RJ45 connector, depending on version
Installation
Upright, high and away from metal- At a position
The QUADRO module stands strictly upright, antennas up, in an open spot — as high as possible and away from metal surfaces. Never lay it on its side: the sealing is designed for the top cover.
- On a vehicle
Keep the module as far as possible from the metal roof. The best spot for the receiver is the bonnet or a bull bar.
- Next to an EW jammer
An EW jammer working on adjacent frequencies can blind the detector. Separate the module and the jammer in height and distance, and add constant interference from your own jammer to the ignored-frequency list.
Kit contents
Standard
- Control unit with screen
- Sealed QUADRO remote module
- GX12 (5-pin) or RJ45 antenna cable
- Power cable 5.5×2.1 mm → XT60
Options
- Remote control panel mirroring the main unit’s readings
- Battery version, 20 000 mAh





